JustAnswer
>
Car
Ask A Question
|
Register
|
Login
|
Help
Car
Ask a Car Question, Get an Answer ASAP!
Have your own Car question?
27 Auto Mechanics are Online Now
characters left:
Not a Car Question?
Related Car Topics:
Add
,
Lid
,
Run
,
Top
,
Come
,
Cool
,
Fill
,
Lamp
,
Olds
,
Nuts
Question
What steps do I take to get at the panel lights in the dashboard of a 94 Nissan Quest? Need to change bulbs. Also want to flush cooling system and replace coolant in a 2002 Olds Alero. V6 automatic. How do I go about it?
Submitted: 18 days and 11 hours ago.
Category: Car
Value: $16
Status: CLOSED
+
Read More
Optional Information
Year: 1994
Make: Nissan
Year (other): 2002
Make (other): Olds
Model: Alero
Engine: V6 Automatic Trans.
Already Tried:
Nothing Yet
Posted by
TIM MOHR
18 days and 10 hours ago.
Answer
Hi, my name is Tim, to replace the instument panel bulbs, the instrument cluster must be removed, I will post that procedure below. To flush the coolanton the olds, loosen the drain plug on the radiator and drain the coolant, i use prestone super flush, close the drain on the radiator, and add the flushing chemicals,and fill with water, start the vehicle and let run untill it has reached full temp, let the vehicle cool and open the radiator drain, and drain all the fluid out, then close the drain and fill with water. start the vehicle again and let it come to temp, let it cool and drain the radiator again, repeat this until the water is clear, then drain again, fill with 1.5 gallons of straight anti freeze, and top off with water, run vehicle to temp and check the level, add if neccessary,Tim
Accepted Answer
Notes
Disconnect battery ground cable remove lower console center cover, then lower instrument cover.
Disconnect lamp harness connector.
Remove instrument pocket, then lefthand side lower instrument panel.
Remove lefthand side knee reinforcement plate.
Remove steering column to instrument panel mounting nuts, then lower steering column.
Remove instrument cluster lid.
Remove instrument cluster to instrument panel attaching screws.
Pull cluster rearward and disconnect cluster harness connectors.
Remove cluster from vehicle.
Reverse procedure to install.
Expert:
TIM MOHR
Pos. Feedback:
100.0 %
Accepts:
Answered:
11/4/2009
ASE MASTER TECH
30 YRS EXPERIANCE, AUTO AND TRUCK,FOREIGN AND DOMESTIC, GAS AND DEISEL
+
Read More
Related Car Questions
1.I want to buy a common rail system tester (CRS 1000). I wa...
hi i have a 1994 subaru legacy and when i am driving the eng...
03 envoy will not go into 4h or 4l but will go into awd no
why does my 97 olds aurora's engine shut off when i'm going
how do i keep the hood of my '88 jag j6 from sticking and wh...
Can you tell me the estimated cost to replace the alternator
My RIO 5 will not start this morning. Fast clicking noise
I have a 1990 olds cutlass supreme with a 3.1 engine.I had