JustAnswer
>
Volvo
Ask A Question
|
Register
|
Login
|
Help
Volvo
Ask a Volvo Question, Get an Answer ASAP!
Have your own Volvo question?
4 Volvo Mechanics are Online Now
characters left:
Not a Volvo Question?
Related Volvo Topics:
Cut
,
Ecm
,
Fix
,
May
,
Obd
,
Oem
,
Red
,
S60
,
Top
,
Two
Question
2002 S60 24T Check engine light. OBD code PO135 bank1 oxygen sensor heater. Replaced sensor with Bosch universal lBS15733 Four wire Black Grey 2xWhite. OEM wire Bl Wt Grey Red Yellow. Connected blacks and grays. Tried single and double connection of two replacement whites. Reset check engine code. still getting check engine with heater error. Will appreciate any/all help.
Submitted: 24 days and 18 hours ago.
Category: Volvo
Value: $30
Status: CLOSED
+
Read More
Optional Information
Already Tried:
1
Posted by
Philip
24 days and 18 hours ago.
Answer
The problem is with the sensor you installed, volvo is very critical when it comes to sensors and vital engine electronics. Basically you need to get a Volvo OEM part from the dealer as your replacement part. When you installed this universal sensor did you have to cut the harness to install the sensor? The ECM uses resistance values in its heater circuits as information, the aftermarket part you installed is not going to read the same as OEM.
24 days and 17 hours ago.
Reply
Really appreciate your quick response. OUCH! $340.70 at the local Volvo bandit store. Two questions. I see some $150 or so Bosh "direct replacements" Do yo know of any in that range that would work? Second where is the connector end of the sensor located? Possibly a 3rd if not against the rules, How in the heck do you change the right front turn signal? Thanks again Larry
Accepted Answer
Dont waste your time and money with direct replacements, it may be expensive but OEM is the only fix, the connector end is on the transmission side of the enginebay toward the back on top of the trans, the r/f turn signal is tight isnt it? You must remove the washer fluid resevoir neck by removing the torx 25 holding it on, then reach down and turn the grey connector, a tip for installation is to lube the seal on the socket so it turns easier, oh and dont just change the bulb, it needs the socket as well.
Expert:
Philip
Pos. Feedback:
100.0 %
Accepts:
Answered:
10/28/2009
ASE Certified Technician
4 ASE Certifications, 7yrs dealership employed, 6yrs Volvo factory trained
+
Read More
Related Volvo Questions
volvo-c-70-2004- the plastic rod broke so the sun visor will
Volvo 850 AWD rear end drive problem-serious clunking with
how do i replace a heater core from a 1993 volvo 850 glt
1984 240 Electrical components quit: Turn signals, windshiel...
I have a 2002 Volvo V70 qith around 103,000 miles. The chec...
Tonight I pulled into my driveway and put it in p ark but ac...
I'm looking at a 1995 Volvo 850 wagon to purchase. It says
how hard is it to change the heater core on a 1994 volvo 850