JustAnswer
>
Car
Ask A Question
|
Register
|
Login
|
Help
Car
Ask a Car Question, Get an Answer ASAP!
Have your own Car question?
39 Auto Mechanics are Online Now
characters left:
Not a Car Question?
Related Car Topics:
Cam
,
Far
,
Pdf
,
May
,
Two
,
Bank
,
Bolt
,
Come
,
Hose
,
Pics
Question
Hello, I have a 2004 Nissian Maxima SE with a 3.5 V6. It stalls in the middle of driving and is hard to start.Iv'e read online that it could be the camshaft position sensor, and on this engine there are two.I had the codes read an this was confirmed. Is this somethiong I could replace as a pretty good diyer.? Will i need a manuel.? Is there a website that may have pics to show me.? Thank You for your expertise Mike
Submitted: 48 days and 3 hours ago.
Category: Car
Value: $23
Status: CLOSED
+
Read More
Optional Information
Year: 2004
Make: Nissan
Model: SE
Engine: 3.5
Already Tried:
A tune-up, Check coil packs
Posted by
carguy1
48 days and 3 hours ago.
Info Request
HI there!This is something that you can do on your own. Do you need both or just one and which bank if only one? Let me know! Thanks
48 days and 3 hours ago.
Reply
The codes were read at a local Auto zone.I'll replace both camshaftsensors while I'm doing it.But where can i go as far as a reference for the location of them, if this is something i can do.?
Accepted Answer
HERE
are the locations. It is a simple process on tha cam sensors. One ten mm bolt and they come right out,disconnect the connector and install the new one. That easy. Bank 1 is a little tricky to get to,but you can do it without removing anything.Except for the air hose going to the throttle.
Expert:
carguy1
Pos. Feedback:
99.3 %
Accepts:
Answered:
10/6/2009
Auto Service Technician
25years experience,certified subaru technician,Nissan factory trained
+
Read More
Related Car Questions
wont fire
starting 91 honda accord
2000 Acura TL
Where is the blower motor resistor on a 2000 mercury mystiqu...
I am looking for a wiring daigram for a 2002 saturn vue
serpentine belt routing
Audi problems
1991 Chrysler No Start when warm