Answer

Hello and welcome to Just Answer!

The film is rewound directly from the take-up reel to the supply wheel.

Attach the film to the supply wheel by holding the end against the core of the reel and turning the reel at least one turn counter-clockwise.

Make sure that the first turn is tight against the core and that there is no slack between the reels.

Place the Upper Belt on the Upper Pulley to drive the supply wheel.

Remove the lower belt from the lower pulley.

Start the motor and be sure the lamp is off,as the motor drives the Upper Pulley and rewinds the film,put enough retarding pressure on the lower take-up reel with the fingers to obtain a snug wound .compact coil of the film on the supply reel.

After the film is completely rewound,shut off the motor.

Remove the upper belt from the upper pulley and replace the lower belt on the lower pulley and you are ready to thread your next reel of film!

I am also including the site I found the manual on so if you run into any problems you can review it, or if you need other instructions!

http://www.manualsonline.com/mdownloads/4938b980-de41-46ed-89f8-a3512186ecab.pdf

Please remember to click the green accept button, so the site pays me for my help!

And,"POSITIVE FEEDBACK" only takes a moment and is very important in my work!

Thank-You !

Expert:	danny541
Pos. Feedback:	94.3 %
Accepts:
Answered:	8/26/2009

Top General Researcher

Just enjoy researching in all areas.