Answer

Welcome to just answer. Here is the procedure. If you need anything else just let me know. If you accept this please hit the green payment tab. Bonuses are always appreciated. Thank you.

Operation

Manual adjustment of drives
The adjustment switches in the switch block are used for adjusting the seat manually. The adjustment switch (with integrated control module) is located on the sides of the seats facing the door.

The following adjustments can be made with these switches:

• Seat fore/aft adjustment
• Seat height adjustment
• Seat angle adjustment
• Seat angle adjustment
• Head restraint height adjustment (comfort seat E64)

An additional switch for the Easy Entry is fitted in the E64 in the seat, enabling rapid forward / back adjustment of the seat.

Programming a memory position

• On the vehicle, the ignition lock must be in position 1 or 2.
• Activate the memory button on the memory switch. Programming readiness is indicated by the memory button lighting up.
• Press one of the 3 position buttons to store the current seat position.
• The indicator lamp goes out after pressing the position button.
• Program readiness is canceled if no position button is pressed within 7 s . The position button goes out.

Calling up a memory position
A differentiation is made between two operating modes when stored seat positions are retrieved:

• Touch button operation: In single-strike mode, it is enough to briefly press one of the 3 position buttons to start the positioning procedure. Positioning runs automatically until the target position is reached.

The touch button operation is effective if the driver's door is opened and the ignition-lock is in position 0 or 1.

With the driver's door closed, touch button operation is effective in ignition lock position 1.

• Continuous button operation: To call up a seat position, the corresponding position button must be pressed continuously to maintain positioning. If the button is released before the target position is reached, the corresponding drive is switched off immediately. The positioning procedure is continued when the position button is pressed again. If another position button is pressed, the positioning procedure for the new position is started.

The continuous button operation is effective if the driver's door is opened and the ignition-lock is in position 2.

With the driver's door closed, continuous button operation is effective in ignition lock position 0 or 2.

Detection of end stops
In order to avoid unnecessary engine load and of the ripple count module, there is automatic detection of the adjustment range limits.

Should a block be detected several times in the same position, the detected position value is interpreted as the end stop. Any further adjustment is terminated before this limit is reached.

An incorrectly detected end stop (e.g. blocking of the seats caused by objects lying around) can be overridden after removal of the blocking, by activating the manual adjustment switch.

Expert:	marcpod
Pos. Feedback:	91.3 %
Accepts:
Answered:	5/28/2009

Own collision repairadvice.com

i-car/Basf training, 300 repairs and 650,000 in Collision work monthly