JustAnswer
>
Lexus
Ask A Question
|
Register
|
Login
|
Help
Lexus
Ask a Lexus Question, Get an Answer ASAP!
Have your own Lexus question?
3 Lexus Mechanics are Online Now
characters left:
Not a Lexus Question?
Question
Hi I have just installed new head gaskets on a 3vzfe motor after blown gasket and rough idling. Checked timing twice belts cams and ignition. I have good spark good fuel press and injectors working OK. When I crank engine it will not fire and when I then remove the plugs they are very wet. Prior to reinstalling throttle body I did crank the engine , it started and ran for about 5 secs then died this would confirm that timing is OK. Any ideas Thanks Tony
Submitted: 265 days and 6 hours ago.
Category: Lexus
Value: $15
Status: AWAITING EXPERT REPLY
+
Read More
Posted by
Peter
265 days and 6 hours ago.
Info Request
What year ES is this Lexus?
Started the car without throttle body installed???????????
Edited by Peter on 3/3/2009 at 12:39 AM
265 days and 6 hours ago.
Reply
Hi Peter Its a jap import to New Zealand 1991 equivlent to ES300 with The 3.0lt 3vzfe motor quad cam. I cranked it without throttle body and with timing light to confirm correct ign timing.It is similar to the 1mzfe motor but only one coil and cams mesh in the middle of the shafts as opposed to the1mz that meshes at the end.
265 days and 6 hours ago.
Reply
When shunting E1 and T1 on the DLC there are no fault codes displayed
+
Read More
Related Lexus Questions
my drivers car door wont open from the outside, the ...
FYI, On my 1999 RX 300 I just had timing belt, water pump,
Does carrying extra weight in the trunk of your car cause .....
Hi,how can I tweak out my 1mzfe engine in my 2001 RX300?
i have a 2002 gs 430 and it will not start, and if it does ....
my girlfriend just recently bought a 2000 rx300 less than a ...
ls 400 rear rotor removal
can you send me a diagram on how to remove the throttle ...