Answer

Thank you for your question hope this helps.

 

The blower motor resistor has gone out. The resistor works like a volume nod on a radio

when it goes bad the power is only on the high setting.

 

Blower resistors are located is under the dash on the passenger side right next to the blower motor the screws are 1/4 in, not metric not to hard of a fix except that one screw in the back.

 

Removal & Installation

 

To Remove:

1. Remove the right side instrument panel lower insulator.
2. Disconnect the blower resistor electrical connector.
3. Remove the blower resistor screws.
4. Remove the blower motor resistor.

To Install:

1. Install the blower resistor.
2. Install the blower resistor screws.
3. Connect the electrical connector to the blower resistor.
4. Install the right side instrument panel lower insulator.

	View Full Image

 

Hope this helps

Good luck