Reply to supertech's Post: Thank you for a response but in general I gave you what was necesary to answer my needs but I will answer your questions here too,

Ok it is a Chrysler seabring 142,000 miles 1998 all works great sat in the desert in a garage for a year while I relocated, got it back top worked fine as the year progressed the top began acting tired MOTOR WORKED just slow to lift and raise as time went on it became to labours to raise and lift, so I stopped using it , learned where the hydraulics were replaced both lines as one was cracked and am simply trying to learn how to bleed it, I did open one end then turned the motor on to allow some air to escape... it did and it does barely lift now feels as if there is more need to bleed.... there is not a bleed valve only a canister with the hose to it and back out of it a T hose goes from the hydraulic canister out to the top arms on top and bottom like 4 ways out and back?...

Thank you but your answer is not complete. HOW do I get it to bleed there I am not able to find a bleeder valve can you tell how I can bleed it to get it to work the MOTOR WORKS JUST FINE...p please don't answer if you are NOT sure or can not locate the complete answer. It appears to me you are not familiar with the seabring convertible top and how to mechanically work with it.

It is WRONG of you to attempt to cancel my question out and PAY you without truly answering my need. It may be only 15.00 dollars but it is a job and every job deserves full attention. Thank you for either referring me to someone who knows more about Seabring convertible mechanics or give me an answer I can use. I had already did more then you suggest.

It was the way you answered SIR that gave me the feeling you were more interested in getting paid then giving advice....... ALSO quite honestly I was rather disturbed to learn this fee was a one shot question fee......? I would pay a monthly or yearly better then each question...... So maybe I was a bit harsh in general though your answer was vague and f no help... to add it is a self bleeding pump is helpful but in essence I found how to bleed it is by un screwing the pump top screw hold my finger on it raise and lower the top there by bleeding it of the air trapped and thus it worked.