my pictures been acting up all day but i will try any way. i hope i helped and please accept if satisfied. thanks T-MAN

moval and Installation

All vehicles

1. Remove the integrated control panel. For additional information, refer to Climate Control Assembly in this section.

1. Remove the right-side lower instrument panel insulator.

	View Full Image

1. Lower the glove compartment.

Vehicles with EATC

1. Remove the 2 remote climate control module screws and position the module aside.

	View Full Image

All vehicles

1. Remove the temperature blend door linkage shield.

	View Full Image

1. Remove the temperature blend door actuator (19E660).
   1. Disconnect the electrical connector.
   1. Remove the screws.
   1. Remove the temperature blend door actuator.

	View Full Image

1. To install, reverse the removal procedure.

View Full Image

Radio Removing Tool 415-001 (T87P-19061-A)

All vehicles

1. Using the special tool, pull out the integrated control panel (18C858).

	View Full Image

Vehicles with manual climate control

1. Label and disconnect the electrical connectors. Remove the integrated control panel.

	View Full Image

Vehicles with electronic automatic temperature control (EATC)

1. Label and disconnect the electrical connectors and the in-car temperature sensor hose (19D888). Remove the integrated control panel.

	View Full Image

All vehicles

1. To install, reverse the removal procedure.

no this is all, sometimes the ford pictures would work and sometimes it's like ford blocks them out somehow, but everyone is having this problem, but if you like i could opt. out and give you to another expert and let him try. please reply. thanks

Hi, below is the same procedure as the other expert posted except my pictures posted,the actuator is behind the center of the dash behind the radio/ac panel assembly, you can buy the radio tools at a local parts store, thanks

	View Full Image

	View Full Image

	View Full Image

	View Full Image

	View Full Image