Answer

Here are exact instructions with pictures. Thanks

 

Signal Bulb Replacement

Removal Procedure

Caution: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments. To help avoid personal injury:

•	Turn off the lamp switch and allow the bulb to cool before changing the bulb.

•	Leave the lamp switch OFF until the bulb change is complete.

•	Always wear eye protection when changing a halogen bulb.

•	Handle the bulb only by its base. Avoid touching the glass.

•	Keep dirt and moisture off the bulb.

•	Properly dispose of the used bulb.

•	Keep halogen bulbs out of the reach of children.

 

Notice: Avoid touching the bulb or letting the bulb come in contact with anything damp. Oil from your skin or moisture on the bulb can cause the bulb to explode when the bulb is turned on. If either comes in contact with the bulb, clean the bulb with alcohol or a suitable degreaser and wipe the bulb dry.

	View Full Image




1. Ensure that the headlamp switch is in the OFF position.
2. Ensure that the ignition switch is in the LOCK position.
3. Remove the headlamp assembly retainers by pulling up and outward.
   

   	View Full Image

   
   
   
4. Disconnect the lamp electrical connectors.
   

   	View Full Image

   
   
   
5. Remove the headlamp assembly from the vehicle.
6. Push and rotate the bulb 1/4 turn counterclockwise in order to remove the bulbs from the headlamp assembly.

Installation Procedure

	View Full Image




1. Push in and rotate the bulbs 1/4 turn clockwise in order to install the bulbs to the headlamp.
2. Connect the lamp electrical connectors.
   

   	View Full Image

   
   
   
3. Install the headlamp assembly to the vehicle.
   

   	View Full Image

   
   

   	View Full Image

   
   
4. Install the headlamp assembly retainers by pushing down and inward.