Answer

Hello

Unfortunately there is no way to by pass the factory alarm

There a few ways to shut it off

one use the remote to unlock the doors with the doors shut

if the remote is not working unlock the drivers door with the key if the drivers door does not work unlock the passengers door with the key

If none of these works you can jump the door disarm switch by removing the drivers door panel, and look up into the door you will be able to see the lock cylinder coming through the door skin, on the back of the cylinder there is a disarm switch follow the wiring down to the two way connector near the rear of the door, disconnect this connector and using a suitable jumper wire jump th two harness side pins together momentarily, This should disarm the alarm allowing the car to run, if not you may have problems not strictly related to the alarm, if it worked and unlocking the doors with the key did not you will need to replace the disarm switches, if one door disarmed the alarm only the other doors switch will need to be replaced

be careful not to lock the doors with the electric switch or with the keys or remotes until repaired as this will turn the alarm active and you will have to do it all over again

Hope this helps and gets you on your way

If you need more information just let me know

Thank you

Donny

Expert:	Donny
Pos. Feedback:	100.0 %
Accepts:
Answered:	2/16/2008

ASE Certified Technician

A.S.E. Master Technician, Over 25 years working in Chrysler dealers, Top tech DaimlerChrysler 1998