Thanks for replying back to me. You were offline when I responded earlier.
To replace the wiper blade assembly, you will need to disassemble most of the printer.
1.Remove the Control Panel Cover2.Remove the Left Side Cover3.Remove the Right Side Cover4.Remove the Exit Cover5.Remove the Ink Loader6.Remove the Funnel Cap7.Remove the Jetstack Cap8.Remove the KL-Clip that secures the left side Wiper Blade Drive Gear9. Then replace the wiper blade with a new one.
Here is a link to the service manual. The parts are shown in section 8:
Kindly rate my service 5 stars on your question page so I am credited for my time; tips appreciated :)
Hi, just checking in on your question, do you need any further assistance?