How JustAnswer Works:

  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.

Ask Nathan Your Own Question

Nathan
Nathan, Engineer
Category: Printers
Satisfied Customers: 21477
Experience:  Computer networking/repair. 12+ years experience.
59725966
Type Your Printers Question Here...
Nathan is online now
A new question is answered every 9 seconds

My MP 210 printer was moved to our new homw ND NOW HANGS UP

Customer Question

my MP 210 printer was moved to our new homw ND NOW HANGS UP SHOWING A "PAper Jam" when there is none. What is wrong?
tHANX,
don
Submitted: 10 months ago.
Category: Printers
Expert:  Nathan replied 10 months ago.

Hello, I’m Nathan, and I’ll be assisting you today. My livelihood depends on your positive feedback, so your satisfaction is my highest priority.

Sorry to hear you’re having trouble, Donald.

This is a “diffuse” message which simply denotes an internal fault. That can be caused by anything from debris/obstruction (paper jam, bent/damaged rails, out of place purge assembly/wiper, or dirty/dislocated encoder strip) to an actual hardware defect (bad sensor or control board, faulty carriage drive motor/gear/belt, bad printhead/carriage pcb).

What we can try here are some cleaning and reset steps.
First, open up the printer, and check for any internal debris such as scraps of paper, paperclip or staple, etc. First remove the input paper supply.

Check if you’re able to move the carriage manually, or if it moves on its own when lifting the lid. If it does move, you can proceed with cleaning by blowing out the Inside compartment with compressed air and checking carefully on both sides for any obstructions. Next remove all of the ink cartridges, then clean the metal electrical contacts on the back, as well as where they mate up inside the printer, using qtips and rubbing alcohol. Dry well, then reseat the cartridges. Then wipe down the encoder strip, which is a clear plastic strip running the width of the printer, that sits just slightly above and behind the carriage. Slide the paper guides to the center then back out, fan the front edge of the paper stack, and replace the paper supply.

Then reset the machine:
unplug power at the wall outlet
wait 5 minutes
press and hold the power/on button for 60+ seconds
keep holding while plugging back in, and for another 60 seconds after, then release

Let me know the results, and I’ll advise further if needed.

Nathan

Expert:  Nathan replied 10 months ago.

Do you need more help with this, Don?