Lift the Scanning Unit (Cover) (A) until it stops.
Close the Document Cover (B) and lift it with the Scanning Unit (Cover).
The Print Head Holder (C) moves to the installation position.
If the Print Head Holder does not move, make sure that the machine is turned on.
For details, refer to 3 to 6 in [ Preparation ]
Firmly lift the part (D) of the Print Head Lock Lever in the Print Head Holder until it stops.
Remove the Print Head from the silver package.
Remove the orange protective cap.
Tilt the Print Head forward and set it in place as shown.
Hold the Print Head Lock Lever firmly and lower it completely.
(1) Remove the orange tape completely.
(2) Remove the protective film completely.
Hold the ink tank with the orange protective cap (A) pointing up while being careful not to block the L-shape air hole (B).
Hold the ink tank by its sides and slowly twist the orange protective cap 90 degrees horizontally to remove it off.
Do not push the sides of the ink tank.
Tilt the ink tank, then insert it under the label and against the back end of the slot.
Make sure that the color of the label matches the ink tank.
Press the PUSH mark on the ink tank firmly until it clicks.
When the installation is completed properly, the Ink lamp lights red.
Install all the other ink tanks in the same way according to the color order indicated on the label.
Make sure all the Ink lamps light red.
Lift the Scanning Unit (Cover) (E) slightly, then gently close it.
Make sure the Inner Cover (F) is closed.
Make sure that the LCD changes as shown in the illustration and go to the next step.
Do not press the OK button yet.