How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Santonu Your Own Question
Santonu
Santonu, Computer Support Specialist
Category: Printers
Satisfied Customers: 3831
Experience:  Diploma in Hardware
13934950
Type Your Printers Question Here...
Santonu is online now
A new question is answered every 9 seconds

How do you change an ink cartridge in an Epson Stylus NX400

Resolved Question:

How do you change an ink cartridge in an Epson Stylus NX400 printer?
Submitted: 7 years ago.
Category: Printers
Expert:  Santonu replied 7 years ago.
Hello,

Please use the following steps:


1.Turn on the printer

If a cartridge is low or expended, you see a message on the Epson Stylus NX400 Series LCD display screen.


If you’re replacing a cartridge before you see a message on the Epson Stylus NX400 Series LCD display screen, press Setup, select Maintenance, and press OK.

Then select Change Ink Cartridge and press OK.


2. Open the scanner.

graphic



3 Open the cartridge cover.


graphic


4. Squeeze the tab on the cartridge and lift the cartridge straight up to remove it.


graphic

5 Before opening the new cartridge package, shake it four or five times. (Do not shake a cartridge after opening the package; ink may leak.)


6 Remove the cartridge from the package, but be careful not to touch the green chip on the cartridge.



7 Remove the yellow tape from the bottom of the cartridge.

graphic



8 Insert the new cartridge into the holder and push it down until it clicks into place.



9 Once you replace all the necessary cartridges, close the cartridge cover and push it down until it clicks into place.

graphic


10 Lower the scanner.


11 Press OK to begin charging the ink. This takes about 2 minutes. When you see a completion message on the LCD display screen, ink charging is finished.




I hope this will help.


Thanks



Santonu and other Printers Specialists are ready to help you

Related Printers Questions