How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask poolguy810 Your Own Question
poolguy810
poolguy810, owner - pool and spa service company
Category: Pool and Spa
Satisfied Customers: 1671
Experience:  Servicing pools and all brands of spas for over 28 years.
32482502
Type Your Pool and Spa Question Here...
poolguy810 is online now
A new question is answered every 9 seconds

I have an old Jacuzzi Z115 Hot tub. Six months ago I

Customer Question

I have an old Jacuzzi Z115 Hot tub. Six months ago I replaced the Board, Hi limit sensor, water temperature sensor, and new filter. Last week I put in a new pump. So basically everything is new. I refilled the tub and when the water comes up to temp, the system shuts down and the LED blinks steady. I can shut off the breaker, let it set for 15 minutes turn it back and and it does the same thing. I am at a loss. Any ideas?
Submitted: 1 month ago.
Category: Pool and Spa
Expert:  Webb-Guy replied 1 month ago.

Have you inspected the pressure switch?

Customer: replied 1 month ago.
It's 6 months old. That was replaced along with the other parts.
Expert:  Webb-Guy replied 1 month ago.

what led light is blinking?

Customer: replied 1 month ago.
The only one on the unit. there is not LCD read out. Just a LED next to the temp knob. It blinks steady after the system shuts off. I removed the Hi temp sensor from the heating element tub and system will run fine now, but the heat status led does come on. I am assuming its not heating due to the Hi limit not being in place. Sounds like that might be my problem.
Expert:  Webb-Guy replied 1 month ago.

I thought you said you had already replaced the hi temp sensor?

Related Pool and Spa Questions