How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask garrygoeson Your Own Question
garrygoeson
garrygoeson, Home Appliance Technician
Category: Pool and Spa
Satisfied Customers: 469
Experience:  Over 27 years Repairing Pool & Spa Equipment,Gas Heaters,& Whirlpool Bath Tubs. Certified by many Pool & Spa Manufacturers.
64048604
Type Your Pool and Spa Question Here...
garrygoeson is online now
A new question is answered every 9 seconds

Master spa not working on start up I get 133 11 3-6 then Pr

Customer Question

master spa not working on start up I get 133 11 3-6 then Pr
Submitted: 9 months ago.
Category: Pool and Spa
Expert:  garrygoeson replied 9 months ago.

Hi John:

My name is Garry. I'll be glad to assist you with your spa.

Customer: replied 9 months ago.
lets type
Expert:  garrygoeson replied 9 months ago.

The numbers you see on start up are Software ID numbers. followed by PR which means the pump(s) are in the priming mode.

Customer: replied 9 months ago.
Master spa legend series LS 1050 Replaced topside control panel all looks good on the panel but nothing is working
Expert:  garrygoeson replied 9 months ago.

As soon as PR is seen push all the Jet buttons to start the pumps

Customer: replied 9 months ago.
Nothing works after done with priming I will try
Expert:  garrygoeson replied 9 months ago.

Are you saying that after pushing Jet button with PR in display, pump will not turn on?

Customer: replied 9 months ago.
nothing the topside panels show the pumps are running but nothing is running
Customer: replied 9 months ago.
Expert:  garrygoeson replied 9 months ago.

If the panel shows the pumps are running, but everything is dead, check the fuses on the board.

Customer: replied 9 months ago.
ok
Expert:  garrygoeson replied 9 months ago.

What is the year your spa was manufactured?

Customer: replied 9 months ago.
2005
Expert:  garrygoeson replied 9 months ago.

OK. I'll look up that year for a schematic.

Customer: replied 9 months ago.
ok thanks
Expert:  garrygoeson replied 9 months ago.

Were you able to check the board for any fuses? The manual does not show a schematic for your spa.

Customer: replied 9 months ago.
I have an electrician coming here at 300 I get back to you then Thanks
Expert:  garrygoeson replied 9 months ago.

I do know that many boards have fuses to protect the motor circuits. Most are rated at either 20, 25, or 30 amps. Since you are getting the indication that the pumps are running on the display, there is a good chance the fuses on the board may have blown.

Expert:  garrygoeson replied 9 months ago.

Please post your findings here after the electrician checks the spa. Thank you.

Customer: replied 9 months ago.
ok Thanks I will
Customer: replied 9 months ago.
fuses are all good what next
Customer: replied 9 months ago.
Ready what next
Expert:  garrygoeson replied 9 months ago.

Next, you will need to check voltages at the terminal block on the circuit board. You will need a voltmeter that can read up to 240 volts AC.

Related Pool and Spa Questions