How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Hank_F Your Own Question
Hank_F
Hank_F,
Category: Pool and Spa
Satisfied Customers: 14745
19372534
Type Your Pool and Spa Question Here...
Hank_F is online now
A new question is answered every 9 seconds

I have code 32 coming up. The unit was running and went to

Customer Question

Hello I have code 32 coming up. The unit was running and went to the pool came back and it was off. If I were to let it sit for a little it starts then stop then code blinks. Cables seem fine oil is a year old. 15w 40. Batteries are good. Anything else. Code it be something in the panel. Or black box in the gen set box?
Submitted: 1 year ago.
Category: Pool and Spa
Expert:  Hank_F replied 1 year ago.

Code 32 is Low Cranking Speed Sense.

If the engine actually starts and runs for a few seconds, then shuts down, your controller is most likely bad.

But to verify, connect a frequency meter to the output leads of the genset.

Press and hold the start button to keep the engine running for 4 or 5 seconds, and note the frequency.

If the frequency is about 60 Hz, the controller is bad.

If the frequency is below about 50 Hz, there is a problem in the generator end.