How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Billy Your Own Question
Billy
Billy, Technician
Category: Pool and Spa
Satisfied Customers: 22465
Experience:  Licensed in Hydronics and Boilers
12672042
Type Your Pool and Spa Question Here...
Billy is online now
A new question is answered every 9 seconds

I have a 1991 Sundance 800 series single pump 2 speed, When

Customer Question

I have a 1991 Sundance 800 series single pump 2 speed, When I went to start it up after I replaced the control panel and changed out the seals on the pump the jets seem to run fine for about 20 to 30 seconds then the flo indicator comes on shuts down the pump and it flashes from the temp to flo. I tried it without the filter and changed out my flo switch but it still does the same thing after I reset the breaker, Runs for a 20 seconds then the flo indicator comes on and cut out the pump.
Submitted: 1 year ago.
Category: Pool and Spa
Expert:  Billy replied 1 year ago.
Hello,
do you have enough flow to close the switch? Pump is moving water at normal rate? Filter clean? Have you turned on pump then jumped flow switch as a test?
use reply

Related Pool and Spa Questions