How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Billy Your Own Question
Billy
Billy, Technician
Category: Pool and Spa
Satisfied Customers: 22097
Experience:  Licensed in Hydronics and Boilers
12672042
Type Your Pool and Spa Question Here...
Billy is online now
A new question is answered every 9 seconds

Put in a new heat exchanger old one leaking bad new ignighter

Customer Question

Put in a new heat exchanger old one leaking bad new ignighter lights up burns 10 seconds goes out. Code says ignition failer
Submitted: 1 year ago.
Category: Pool and Spa
Expert:  Billy replied 1 year ago.
Hello,
is the flame reaching the sensor and staying in contact with it?
Use reply please
Customer: replied 1 year ago.
it was working before the h e split open I'm wondering if the gas lines are full of water I'm going to check that tonight
Expert:  Billy replied 1 year ago.
That could be possible...run a full purge...the gas valve could have been compromised also internally
Customer: replied 1 year ago.
this thing it's not throwing codes any more it just keeps cycling burner on burner off
Expert:  Billy replied 1 year ago.
did the ign control get wet?
Customer: replied 1 year ago.
after 12 times it bac to ign failed
Customer: replied 1 year ago.
I don't believe so
Expert:  Billy replied 1 year ago.
can you see the burner at time of ignition?
Does the burner light fully?
Customer: replied 1 year ago.
it looks like it but I can't see all the way back I did take the gas tube loose and clean the orfices I didn't have a tip cleaner to cleaner them real good

Related Pool and Spa Questions