How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Machinc Your Own Question
Machinc
Machinc, General Contractor
Category: Pool and Spa
Satisfied Customers: 906
Experience:  Has written home improvement articles since 2008. Earned South Carolina Residential Builders License in 1991.
75209918
Type Your Pool and Spa Question Here...
Machinc is online now
A new question is answered every 9 seconds

When replacing the A O SMith SQ1202 pool motor should the motor

Customer Question

When replacing the A O SMith SQ1202 pool motor should the motor come loose from the
Pump easily? It loosens a little but the motor shaft won't let go. Is it threaded inside the pump...how donI get the motor to separate from it?
Submitted: 2 years ago.
Category: Pool and Spa
Expert:  Machinc replied 2 years ago.
I will have your answer in a moment
Expert:  Machinc replied 2 years ago.
The SQ 1202 has a threaded shaft and square flange....
You will have to unscrew it to get it
out........
Other models have a "Stub Shaft" on the Keyed Shaft
They have a C-Flange or Round Face, with 4 bolt holes at 1, 5, 7 and 11 O'Clock. ........
..........Shaft is slotted or "Keyed" to accept a stub shaft. No attached Base.
Expert:  Machinc replied 2 years ago.
Note:
With the threaded shaft some hold the
impeller with a large pair of vice locking
pliers.
Remember , left handed or reverse threaded
shafts can be confusing.
Experiment slowly until you are sure
you are turning the right direction.
Customer
.

Related Pool and Spa Questions