How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Billy Your Own Question
Billy
Billy, Technician
Category: Pool and Spa
Satisfied Customers: 22110
Experience:  Licensed in Hydronics and Boilers
12672042
Type Your Pool and Spa Question Here...
Billy is online now
A new question is answered every 9 seconds

I was cleaning the cartridges and at start up the motor started

Customer Question

I was cleaning the cartridges and at start up the motor started and ran fine then a few seconds later I herd a noise and the pump stopped. I removed the motor and found that the screw that goes into the center of the shaft over the impeller had come out and stopped the motor I put the screw back in put it back together and the motor wont run. the system is a Sta-Rite InelliPro motor model number p6e6y4h209.
Submitted: 1 year ago.
Category: Pool and Spa
Expert:  Billy replied 1 year ago.
hello,
to mak sure there was no back feed amp damage...have you tested volt total to motor when it should be running?
use reply

Related Pool and Spa Questions