How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask poolofficial Your Own Question
poolofficial
poolofficial, Business owner
Category: Pool and Spa
Satisfied Customers: 135
Experience:  CPO, Service & repairs over 16 years
63325860
Type Your Pool and Spa Question Here...
poolofficial is online now
A new question is answered every 9 seconds

I have a Jandy Aqualink RS with a wireless controller. When

Customer Question

I have a Jandy Aqualink RS with a wireless controller. When in SPA mode the air temp and water temp shown on the remote control screen are correct. When in pool mode, the air temp is correct, but the water temp is either showing the air temp, or one degree below the air temp.
There is only one thermostat for both the pool water and the spa water, yet the pool water reading is incorrect. Since the pool water temp is reading so high, the heater does not turn on.
Example from today:
SPA readings
Air 105 degrees
Water 84 degrees
POOL readings
Air 105 degrees
Water 104 degrees
I have the heater set for 88, but based upon the pool readings the heater stays in enabled mode, it won't turn on.
***** *****
Submitted: 2 years ago.
Category: Pool and Spa
Customer: replied 2 years ago.
(Posted by JustAnswer at customer's request) Hello. I would like to request the following Expert Service(s) from you: Live Phone Call. Let me know if you need more information, or send me the service offer(s) so we can proceed.
Customer: replied 2 years ago.
When can I expect some type of a response????
Expert:  poolofficial replied 2 years ago.
From what you are stating, sounds like you have a faulty PC Board.