Recent Feedback
I have a limelight spa. I shut off the breaker, emptied it, cleaned it, refilled it, replaced the filter, then turned on the breaker. The tub says power on, lights work, but jets do not and it isn't heating. I have cut the breaker again, still no luck. Any suggestions?
Welcome, how can I help you today? Sounds like you have an air lock in the pump go under the cabinet and in front of the pump there should be a union on the face part of the pump loosen this union until water starts to leak out let it bleed out for a few seconds then re-tighten the union then reboot the breaker and see if the pump purges itself and the water starts to flow. You can also remove the filter and stick a garden hose down the line to force water into the pump
Experience: Over 24 years in pool and spa service and construction
Which cabinet? I tried the hose in the filter line and it didn't work. Where is the pump? Should I take the whole side off?
Forget it. I tried the hose again and it worked!Thank you. I'm assuming that the heat will kick on.....
Yes now that the pump is running you should have no problem with heat thanks and good luck