Recent Feedback
I had to disconnect my inside jandy control panel for sheetrock work. reconnected now and all lights stay on and unit does not work
Already Tried: reconnected all wires and pressed reset button
hello, recheck the connection at the inside controller, the wires must coincide with the connection at the Jandy control panel. goodluck
Relist: Answer quality.His answer was to make sure wires are connected correctly. Its LABELED what color goes where. OF COURSE I did that. I am NOT paying for this
the reason i said to chk the wiring connection is because that is a common mistake when connecting the low voltage. i have made it when doing an install.if the wiring is correct, chk the wires . make sure there are no breaks and if the in door controller is still not operating then replace the in door controller.
What DOOR controller are you talking about. This is a handy POOL controller. Forget this I have disallowed the charge
I am referring to your IN-DOOR CONTROLLER that you removed from the wall. That is what JANDY calls the item that is installed inside. good luck.