How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Machinc Your Own Question
Machinc
Machinc, General Contractor
Category: Plumbing
Satisfied Customers: 888
Experience:  Has written home improvement articles since 2008. Earned South Carolina Residential Builders License in 1991.
75209918
Type Your Plumbing Question Here...
Machinc is online now
A new question is answered every 9 seconds

My Pentair Water Fleck SXT timer is flashing a "1" error

Customer Question

My Pentair Water Fleck SXT timer is flashing a "1" error code. I ran a manual regeneration and it appeared to work. Then it started to flash a "3" error code. That must have resolved itself but it is now flashing the "1" again. How can I correct this error.
Submitted: 1 year ago.
Category: Plumbing
Expert:  Machinc replied 1 year ago.
I will have your answer in one moment
Expert:  Machinc replied 1 year ago.
The number one code is a step error.
Unplug the ynit for 30 seconds abd plug back in.
Since You have done the manual step through and the problem reoccurred.
Go back to the master setting and verify that the system type and valve type are correctly entered
it could have been accidentally changed or when the fault in the system occured.
Once you have verified this is correct and it still goes back to error code the problem is most likely in your control board and you should probably wait for the repairman to come replace or fix it.
I'll be glad to answer any questions you might have
Customeredited>42198.5269026852