How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Jake Your Own Question
Jake
Jake, Nissan Technician
Category: Nissan
Satisfied Customers: 3655
Experience:  Experienced collision repair technician, Pulaski Tech graduate and DSM hobbyist.
20440119
Type Your Nissan Question Here...
Jake is online now
A new question is answered every 9 seconds

Having some issues stall at low throttle was cutting off at

Customer Question

Having some issues stall at low throttle was cutting off at stops replaced iacv not cutting but still feels jumpy and get a odor from car from time to time
JA: What is the model/year of your Nissan?
Customer: 1998 altima 2.4
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: Plugs iacv and new airfilater and gas filter
JA: Has the vehicle turned into a gas hog? And how does it start -- same as usual?
Customer: Yes it has ltitle harder to start also
JA: Anything else you think the mechanic should know?
Customer: Notice issues more when really hot out.
Submitted: 4 months ago.
Category: Nissan
Expert:  Jake replied 4 months ago.
Hey there thanks for the question.
There is a few possibilities here.Does the car run fine except for the stalling at idle?
Customer: replied 4 months ago.
runs great people don't believe me cause runs really food most of the time
Customer: replied 4 months ago.
Sorry really good most of the time starts to stall after it gets hot
Expert:  Jake replied 4 months ago.
Thanks that helps. Since it stalls when it gets hot. A lot of times these distributors develop a small internal oil leak that messes with the cam sensor signal. If you remove the cap and and lower cover you can generally see the oil intrusion. Replacing the distributor corrects the problem.