How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Infiniti expert Your Own Question
Infiniti expert
Infiniti expert, ase tech
Category: Infiniti
Satisfied Customers: 10370
Experience:  30 years experience
22989858
Type Your Infiniti Question Here...
Infiniti expert is online now
A new question is answered every 9 seconds

2002 Infiniti: left rear door panel & replace the door lock

Resolved Question:

2002 Infiniti M45
I need info. plus pictures on how to remove the left rear door panel & replace the door lock actuator.
Thanks Bill
Submitted: 6 years ago.
Category: Infiniti
Expert:  Infiniti expert replied 6 years ago.
Welcome to just answer.com. I'm here to help you and your 100% satisfaction is my goal. Here's the procedure is outlined in the Manual
Service and Repair

 



FRONT DOOR FINISHER

Removal


 

  1. Insert screw driver rolled with cloth or tapes into dip at front of inside handle escutcheon, and pull it back to your side. Disconnect upper pawl, lower and front, and remove inside handle escutcheon.
  2. Remove cap and screw of power window main switch finisher.
  3. Insert clip driver rolled with cloth into dip under power window main switch finisher, and lift up finisher. Insert your fingers between gaps, pull it back to your side and disconnect metal clips.
  4. Disconnect power window main switch harness connector.
  5. Remove screws of front door finisher.
  6. Remove step lamp, and disconnect harness connectors.
  7. Insert screw driver rolled with cloth into clips under door finisher, and disconnect clips.

 


 

  1. Pull up door finisher, and remove connectors, inside handle cable and lock knob cable.

 



NOTE: Insert screw driver rolled with cloth between panel on vehicle and clips (as indicated with arrow), and remove finisher.

Installation
Install in the reverse over of removal.

CAUTION: To install finisher, check if all clips are matched over holes of panel on vehicle, then push in.

REAR DOOR FINISHER

Removal


 

  1. Insert screw driver rolled with cloth or tape into dip at rear of inside handle escutcheon, and pull it back to your side. Disconnect upper pawl, lower and front, and remove inside handle escutcheon.
  2. Remove ashtray and screw of power window sub switch (rear) finisher.
  3. Insert screw driver rolled with cloth into dip under power window sub-switch (rear) finisher, and lift up finisher. Insert your fingers between gaps, pull it back to your side, and disconnect metal clips.
  4. Disconnect power window sub-switch harness connector.
  5. Remove screws of rear door finisher.
  6. Remove step lamp, and disconnect harness connectors.
  7. Insert screw driver rolled with cloth into clips under door finisher, and disconnect clips.

 


 

  1. Pull up door finisher, and remove connectors, inside handle cable and lock knob cable.

 



NOTE: Insert screw driver rolled with cloth between panel on vehicle and clips (as indicated with arrow), and remove finisher.

Installation
Install in the reverse over of removal.

CAUTION: To install finisher, check if all clips are matched over holes of panel on vehicle, then push in.

 

Infiniti expert and 3 other Infiniti Specialists are ready to help you

Related Infiniti Questions