Recent Feedback
Ihave a 2011 polaris ranger 800xp just bought used 3700 miles. ran fine for a day or two then would sputter monentarily ocassionaly. after hard days use the idle is rough, wants to cut out if you step on it, if you put it to the floor it will run hard for about two seconds then cut out, i changed gas, checked plugs don't see anything wrong. also the check engine light comes on and off
Optional Information: Make: polaris Model: ranger Already Tried: this is a 2011 efi
does the check engine light come off and on when the unit is acting up?
or just randomly does it come on?
Right now it is acting up as soon as you start it up. Check engine light will come on for several minutes then go out for a while and then come back on
If the trouble code(s) are not displayed, use the MODE button to toggle until "CK ENG" displays on the information display area.
1.Press and hold the MODE button to enter the diagnostics code menu.
A set of three numbers will appear in the information area.
2. If more than one code exists, press the MODE button to advance to the next trouble code.
3. To exit the diagnostic mode, press and hold the MODE button or turn the ignition key OFF once the codes are recorded.
let me know the codes you get
ch eng mode will not come up using mode button
The diagnostic mode is accessible only when the check engine MIL has been activated. when the key is on when the key is off it clears the codes.
I think that your knowledgeable but was unable to remedy problem and I have taken utv to dealer.
ok I understand