How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Louie Your Own Question
Louie, Technician
Category: Motorcycle
Satisfied Customers: 11234
Experience:  25+ yrs. experience
Type Your Motorcycle Question Here...
Louie is online now
A new question is answered every 9 seconds

I have an bmx 110 cc atv the wiring is totaled . can I get

Customer Question

I have an bmx 110 cc atv the wiring is totaled . can I get rid of all the shit that is on it an re wire it with a on an off switch. I want to get the thing to run tell me how to hot wire it with some simply wiring applacations
Submitted: 6 years ago.
Category: Motorcycle
Expert:  Louie replied 6 years ago.
Hi and welcome to JustAnswer,

Initially, please determine and postback the colors of the CDI wires.

Offhand, the basic wiring required "...get it running..." for most clones are:
  • bypass alarm and remote;
  • bypass ignition key;
  • handlebar kill switch;
  • handlebar starter switch;
  • disable brakelights, headlights;
  • starter motor and starter relay wiring;
  • CDI, exciter coil, pulser coil and ignition coil wiring;
  • stator, rectifier and regulator wiring;
  • battery.

Good luck and thank you for asking JustAnswer.
Customer: replied 6 years ago.
ok ?? after I get rid of all that What just run a wire from the battery to the starter and turn it over and open the choke
Expert:  Louie replied 6 years ago.
The only needed wiring for the engine to run are the wires to and from the CDI:
  • to the CDI from the exciter coil & pulser coil;
  • from the CDI to the ignition coil.

All the other wirings are for:
  • from the stator to the rectifier / regulator combo - to charge the battery;
  • from the handle bar switch to the starter relay to the starter motor - to initially / start the engine;
  • from the battery to the ignition switch to the harness - lights, alarm, remote.
Louie and other Motorcycle Specialists are ready to help you
Customer: replied 6 years ago.
ok I will try to find all of those componets I doubt I will be success full but thanks ,Mike
Expert:  Louie replied 6 years ago.
I understand though I was hoping to confirm the colors of the wires to / from the CDI. There is one wire from the CDI to the kill switch that would prevent / stop the engine from firing.

For reference, perhaps you could make use of this Honda clone wiring diagram. This require the Adobe Acrobat Reader for viewing and printing.

Appreciate the ACCEPT.

Edited by Benimur on 12/1/2009 at 9:44 PM EST

Related Motorcycle Questions