How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Doug Your Own Question
Doug
Doug, ASE Certified Technician
Category: Mitsubishi
Satisfied Customers: 8541
Experience:  Mitsubishi employed and Factory trained ASE certified technician
21364095
Type Your Mitsubishi Question Here...
Doug is online now
A new question is answered every 9 seconds

Mitsubishi Diamante: immobilizer override code

Customer Question

immobilizer override code
Submitted: 1 year ago.
Category: Mitsubishi
Expert:  Doug replied 1 year ago.
Hi,
For immobilizer serial number A0Y2028A your over ride code will be
3784
To input the code use the following factory instructions:

http://ww2.justanswer.com/uploads/superbovine/2011-06-05_212022_capture.jpg
Note that this is meant to be performed with a dummy key... if you are using a transponder key that is either not-yet-programmed or has lost programming, you will need to shield the RF signal from the key. A few wraps of aluminum foil will shield the signal and allow the over ride to work. If the system reads an RF signal from the key it will -not- allow the over ride to work.
Be very steady/patient with inputting the code. It can be very frustrating sometimes as it is very particular about timing. If you take too long between steps or suddenly go very quickly past one step, it -will- cause a problem. Just get a nice rhythm going and keep it steady and you will be fine with persistence.

Related Mitsubishi Questions