How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Andy Your Own Question
Andy
Andy, Truck Diagnostic Technician
Category: Medium and Heavy Trucks
Satisfied Customers: 1571
Experience:  International trucks, International, Maxxforce and Cummins engines, diagnostic, electrical, Hvac and refrigeration repairs
30303843
Type Your Medium and Heavy Trucks Question Here...
Andy is online now
A new question is answered every 9 seconds

Have a 2008 Ford F750 with Cummins ISB with code SID324 FMI

Customer Question

Have a 2008 Ford F750 with Cummins ISB with code SID324 FMI 0
Submitted: 8 months ago.
Category: Medium and Heavy Trucks
Expert:  Andy replied 8 months ago.

Hi there . My name is ***** ***** I will look this up for you !

Customer: replied 8 months ago.
Engine Serial number 46786038. Original problem was not power stop engine light on and air noise under hood. We found exh. manifold leaking and cracked, we replace manifold with new and gaskets. truck still has code after driving. Unhooked exh pipe b4 part. filter and drove again no change also unplugged all sensor to filter and will not set code other than one described. Still no power stop engine lite on.
Expert:  Andy replied 8 months ago.

Are you sure it is not 3249-0? This would be an afterttreatment fault

Expert:  Andy replied 8 months ago.

Ok scratch that last post . I found it:

Here is the description of the fault and conditions to clear it :

https://www.dropbox.com/s/cjoto2pgf065h8u/08-fc1981%201.pdf?dl=0

And here is the troubleshooting for it :

https://www.dropbox.com/s/qnta68hk3q6dl05/08-t05-1981%202.pdf?dl=0

Please do not forget to rate my service to you .Thanks

Expert:  Andy replied 8 months ago.

Do you still need help ?

Customer: replied 8 months ago.
no checking these things now. Filter has been service and looking at it not plugged, turbo pipe leaking bad and have the ECM flashed we should be good.
Expert:  Andy replied 8 months ago.

Does the fault remain active ?

Expert:  Andy replied 8 months ago.

Are you still there ?

Expert:  Andy replied 8 months ago.

If the fault is still active , you may need to run the conditions for clearing the fault or make it go inactive

Expert:  Andy replied 8 months ago.

Do you still need help ?

Related Medium and Heavy Trucks Questions