How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Wilson Your Own Question
Daniel Wilson
Daniel Wilson,
Category: Medium and Heavy Trucks
Satisfied Customers: 1598
Experience:  Owner at DJ Wilson
Type Your Medium and Heavy Trucks Question Here...
Daniel Wilson is online now
A new question is answered every 9 seconds

I have a kubota 7510HST I engaged the PTO and it doesn't

Customer Question

I have a kubota 7510HST I engaged the PTO and it doesn't disengage with the lever movement any sugessstions
JA: We'll do all we can to help. Tell me a bit more about what's going on so the Heavy Equipment Mechanic can help you best.
Customer: was tilling the garden and disengaged the PTO when I went to put it back in it didn't engage I reclutch it and it engaged. When I tried to disengaged it would not disengage. It does stop if I put the clutch in
JA: Is there anything else the Heavy Equipment Mechanic should be aware of?
Customer: no
JA: OK. Got it. I'm sending you to a secure page on JustAnswer so you can place the $5 fully-refundable deposit now. While you're filling out that form, I'll tell the Heavy Equipment Mechanic about your situation and then connect you two.
Submitted: 4 months ago.
Category: Medium and Heavy Trucks
Expert:  Wayne replied 4 months ago.

Hi I'm Wayne

I will try to help you with this

when you move the lever , can you feel it moving with force ??

or just a simple lever push

Customer: replied 4 months ago.
moves easily
Customer: replied 4 months ago.
all linkage moves cant see if the shaft inside is moving seems to be a rollpin through the linkage but cant tell if the shaft inside of that is moving
Customer: replied 4 months ago.
still there????
Customer: replied 4 months ago.
Are u still there
Customer: replied 4 months ago.
have to go send me a e-mail if u find anything
Expert:  Wayne replied 4 months ago.


Sorry for the delay , had to step out

that is where I was going with this

seems to me that a roll pin broken

would need to take a look at back housing, if it is moving

Customer: replied 4 months ago.
Can't now VB will try to get u tomorrow or Monday
Expert:  Wayne replied 4 months ago.


That is fine, keep me posted

Related Medium and Heavy Trucks Questions