How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Wayne Your Own Question
Wayne
Wayne, Journeyman
Category: Medium and Heavy Trucks
Satisfied Customers: 8422
Experience:  worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling
6825259
Type Your Medium and Heavy Trucks Question Here...
Wayne is online now
A new question is answered every 9 seconds

2007 international 4300, 466e, running on 4 cylinders,

Customer Question

2007 international 4300, 466e, running on 4 cylinders, 6,3,2,1 has had new valve cover gasket installed.
Just bought the truck, has 120,000 kms, previous owner said it was a nightmare
Besides not running right
The cruise, jake brake, air dump, dif loc does not work. Shows no codes.
We took off valve cover found #5 unhooked and #4 grounded out. Fixed it and truck ran very nice, once assembled still ran nice next day went to start and runs on 3 cylinders. Now on the 4 I mentioned. We have check all fuses, cleaned all grounds. Check all switches, where does a person start? Injector harness?
Submitted: 10 months ago.
Category: Medium and Heavy Trucks
Expert:  Wayne replied 10 months ago.

Hi i'm Wayne

I will help you with this

Yes start with replacing the injector harness,

if that does not help matters, then you need to remove the ECM and have it tested

I hope this helped you

Hi if this helped you

Please rate my answer 3 or more stars

If you need more info, use request button

Not Poor/Bad service

Wayne

Customer: replied 10 months ago.
My dealer is saying there is not much that you can check on the ecm if the truck runs the ecm should be good. That it does not store any history.
Also any ideas why the cruise and jake brake does not work?
Expert:  Wayne replied 10 months ago.

Morning

The ECM gets signal from each cylinder,

so it can be in the ECM,

now jakes and cruise, that also goes thru the eCM<,

I suggest to have it removed and tested

Wayne

I hope this helped you

Expert:  Wayne replied 10 months ago.

Hi I'm Wayne

I am just following up with you

Did my answer help you,

Do not use poor/Bad service, use reply button

Wayne