How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Wayne Your Own Question
Wayne
Wayne, Journeyman
Category: Medium and Heavy Trucks
Satisfied Customers: 8451
Experience:  worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling
6825259
Type Your Medium and Heavy Trucks Question Here...
Wayne is online now
A new question is answered every 9 seconds

I have a ford f-350 with a 6.4... I was driving down the

Customer Question

I have a ford f-350 with a 6.4... I was driving down the road and started to hear a rattling sound....after a few miles I could push on the gas pedal and it won't rev up at all it just sits there and idles.....I just replaced 3 egt sensors ....I have a
code that is P132B and P2263
Submitted: 12 months ago.
Category: Medium and Heavy Trucks
Expert:  Wayne replied 12 months ago.

Hi I'm Wayne

I will help you with this

P132B is a code related to the calibration from the recall 06E17. It means that there is a problem with the VGT system. P132B is a fault code that is set if the required boost levels are not achieved during a learn cycle or at specific speed fuel demand points. This code indicates that there are issues with the Turbocharger , MAF sensor, MAP sensor/hose, IAT2 sensor, intake leaks, or exhaust leaks, etc."

Start with cleaning MAP and and IAT2 sensors, and check all the CAC boots for leaks.

Code P2263 refers to a turbo actuator problem or turbo bearing problem caused by possible low engine oil level

I hope this helped you

Hi if this helped you

Please rate my answer 3 or more stars

If you need more info, use request button

Not Poor/Bad service

Wayne

Related Medium and Heavy Trucks Questions