How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Wilson Your Own Question
Daniel Wilson
Daniel Wilson,
Category: Medium and Heavy Trucks
Satisfied Customers: 1634
Experience:  Owner at DJ Wilson
65405794
Type Your Medium and Heavy Trucks Question Here...
Daniel Wilson is online now
A new question is answered every 9 seconds

What causes a 400 engine fordl900 dump truck fly wheel bolts

Customer Question

What causes a 400 engine fordl900 dump truck fly wheel bolts to get loose even when lock tite an torque to about 200 ft pounds ....This has happen over 4 times...i need a solution i dont want it to happen a 5th time .. i really need a solution.
Submitted: 1 year ago.
Category: Medium and Heavy Trucks
Expert:  supertech52 replied 1 year ago.
Okay, thank you for allowing me to help you today on Just Answer. First of all you need to make sure the crank shaft is perfectly flat perfectly clean and the same with the fly wheel surface. Once you make sure that is all clean you are going to clean the bolt holes with brake cleaner fluid and you are going to blow the bolts clean and completely dry. And if possible get new bolts of the correct grade and strength, and make sure they are perfectly clean and dry once again, put the fly wheel up with two studs and then install 271 Lock Tite on each of the fly wheel bolts tighten them up to the minimum spec. remove your studs and install bolts where the studs were and use lock tite also and torque them to max spec torque in a criss cross pattern. There is no way those bolts should come loose now.

Related Medium and Heavy Trucks Questions