How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask cwalkerjr21 Your Own Question
cwalkerjr21
cwalkerjr21, Mechanic
Category: Jeep
Satisfied Customers: 710
Experience:  Shop training and hands on experience.
73583367
Type Your Jeep Question Here...
cwalkerjr21 is online now
A new question is answered every 9 seconds

Fuel pump not energizing. Replaced relay replaced pump

Customer Question

Fuel pump not energizing. Replaced relay replaced pump checked old pump. Power not getting to pump. What did i miss
Submitted: 5 months ago.
Category: Jeep
Expert:  cwalkerjr21 replied 5 months ago.

Good evening, Check the 5 volt reference from pins 17 of the A connector and 31 of the B connector of the Powertrain Control Module. If no 5v reference, unplug the sensors. The sensors that are fed the 5 volt reference are the Manifold Absolute Pressure sensor, Throttle Position Sensor , Crank Position Sensor, Cam Position Sensor, Governor Pressure Sensor and Vehicle Speed Sensor. Check the wiring for a short to ground.

Expert:  cwalkerjr21 replied 5 months ago.

Sometimes the sensors will get the 5v shorted to ground which will cause everything to not get power anymore until it is repaired. There is also a common issue with the PCM wiring and they make a repair kit. I have loaded the PCM connector view and also the TSB about the repair below.

Related Jeep Questions