How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Amedee Your Own Question
Amedee
Amedee, Jeep Technician
Category: Jeep
Satisfied Customers: 24447
Experience:  ASE certified Technician advanced level specialist. Wisconsin certified emissions state inspector
279429
Type Your Jeep Question Here...
Amedee is online now
A new question is answered every 9 seconds

1997 wrangler gauges quit warning lights work in dash

Customer Question

1997 wrangler gauges quit warning lights work in dash cluster fuses look good
Submitted: 8 months ago.
Category: Jeep
Expert:  Amedee replied 8 months ago.

Hello and welcome! My name is ***** ***** I can assist you with your question.

Expert:  Amedee replied 8 months ago.

I take it the engine starts and runs? Are there any codes in the computer? Are you looking for some possible causes or would you like me to walk you through this diagnoses?

Customer: replied 8 months ago.
Engine
Expert:  Amedee replied 8 months ago.

??

Customer: replied 8 months ago.
The gauges don't work oil ,tach,temperature,fuel engine runs fine
Customer: replied 8 months ago.
Fuse all look good ground is good
Expert:  Amedee replied 8 months ago.

Thank you for clearing that up for me.

Expert:  Amedee replied 8 months ago.

Most of the time this problem is caused by a bad instrument cluster. This is very common. Sometimes this problem can be caused by another module on board the vehicle and or a bad ignition switch causing low voltage to the cluster. When this problem occurs, I would check the inputs to the cluster. If all checks out good, replace the cluster and you will be good to go!

Expert:  Amedee replied 8 months ago.

Hello! It's Amedee from just answer.

I am just checking in to see if you need any further assistance?

Let me know!

Related Jeep Questions