How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Chris Your Own Question
Chris
Chris, Shop Foreman
Category: Jeep
Satisfied Customers: 13137
Experience:  Jeep Certified Master Tech
12365498
Type Your Jeep Question Here...
Chris is online now
A new question is answered every 9 seconds

On a 1988 Jeep Comanche pickup 4.0L, I put a new Throttle

Customer Question

On a 1988 Jeep Comanche pickup 4.0L, I put a new Throttle position sensor, but is still stalls at quit stops?
Carl Shipman
Greenville, SC
Submitted: 1 year ago.
Category: Jeep
Expert:  Chris replied 1 year ago.

Hello and welcome to just answer Carl. Did you adjust the TPS after you installed it? Have you cleaned out the inside of the throttle body?

Chris

Expert:  Chris replied 1 year ago.

Carl, not sure if you received my answer, but I found this procedure for adjusting the TPS. Maybe it wil help.

Chris.

=================

1. Disconnect battery ground cable, then remove TPS retaining screws. 2. Disconnect TPS harness connectors and remove sensor. 3. Connect new sensor to transmission TCU harness, then mount sensor on throttle body but do not tighten attaching screws at this time. 4. Check and adjust sensor output voltage as follows: a. Using a voltmeter, connect positive lead to terminal B and negative lead to terminal D. b. Rotate TPS until output voltage is approximately 4.2 volts. c. Tighten TPS attaching screws. If 4.2 volts cannot be attained, replace TPS. 5. Connect battery ground cable.

Expert:  Chris replied 1 year ago.

Carl did you receive my last reply?

Chris