How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, ASE Certified Technician
Category: Jeep
Satisfied Customers: 21598
Experience:  Chrysler/Dodge/Jeep Master Certified, ASE Master and Advanced Certified, Trans and Hybrid Specialist
9825021
Type Your Jeep Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

Grand Cherokee: Installed a 2012 jeep grand Cherokee factory

Customer Question

Installed a 2012 jeep grand Cherokee factory 7 pin tow harness.
Only get reverse lights and tail lights working. No left / right turn signals. Factory harness had multiple wires to hook up, but main 4 were for tail, reverse, left , right turn.
Manual says to hook up to Tipm C5 pins 32 and 15. (park lights & reverse).
The other two wires to Tipm C7 terminals 47 & 48 (left, turn right )
1.) Do you have diagrams for Tipm connector C7 ?
2.) Could pins 47 & 48 be turned off from computer?
Tow harness # ***** says factory must activate but does not say what gets activated.
I'm going to double check my work and make sure I did use pins #47 and #48 on Tipm C1 instead of the correct Tipm C7 47/48.
Submitted: 1 year ago.
Category: Jeep
Expert:  sprinkles08 replied 1 year ago.
Hello and welcome to JustAnswer!
After the wiring is installed the trailer tow brake/turn outputs will have to be turned on using dealer scan tool. It appears you've installed the wiring but haven't had the programming done?