How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask ND-TECH Your Own Question
ND-TECH
ND-TECH, CJDR Master Tech
Category: Jeep
Satisfied Customers: 1410
Experience:  ASE Certified CJDR Master
26707557
Type Your Jeep Question Here...
ND-TECH is online now
A new question is answered every 9 seconds

2011 jeep grand cherokee. how do i reset the service indic

This answer was rated:

2011 jeep grand cherokee. how do i reset the service indicator
If you are talking about for oil changes then you set the ignition to run and with in ten seconds of setting to run press the gas pedal down three times and this will re set it
Customer: replied 4 years ago.
Does not work
You are referring to the message for change oil not the check engine light correct?
Customer: replied 4 years ago.
08/11 JEEP GRAND CHEROKEE, TURBO DEISEL, OIL CHANGE DUE ON DISPLAY

This is directly from your owners manual

Engine Oil Change Indicator System



Oil Change Due

Your vehicle is equipped with an engine oil change indicator system. The "Oil
Change Due" message will flash in the EVIC display for approximately 10 seconds
after a single chime has sounded, to indicate the next scheduled oil change
interval. The engine oil change indicator system is duty cycle based, which
means the engine oil change interval may fluctuate, dependent upon your personal
driving style.

Unless reset, this message will continue to display each time you turn the
ignition switch to the ON/RUN position. To turn off the message temporarily,
press and release the MENU button. To reset the oil change indicator system
(after performing the scheduled maintenance) refer to the following procedure.


  1. Turn the ignition switch to the ON position (Do not start the engine).
  2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.

  3. Turn the ignition switch to the OFF/LOCK position.
Customer: replied 4 years ago.

Still won't work

Make sure the pedal is going all the way down and your are going slow. Also make sure there is a floor mat getting under it as well. If it dosent re set then there is a problem with the system and you will have to take it to a dealer
ND-TECH and other Jeep Specialists are ready to help you