How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Virtual Wrench Your Own Question
Virtual Wrench
Virtual Wrench, Jeep Mechanic
Category: Jeep
Satisfied Customers: 14620
Experience:  35 years Master Mechanic
2617050
Type Your Jeep Question Here...
Virtual Wrench is online now
A new question is answered every 9 seconds

Jeep Grand Cherokee Laredo: 98 jeep grand cherokee, turn signals

This answer was rated:

98 jeep grand cherokee, turn signals are not working, flashers come on but do not flash, I can not find the flasher relay. need help

Hello,

 

The flasher is in the junction block, located on the passenger side kick panel. Replace it and you should be all set.

 

 

graphicgraphic

 

 

 

 

 


Happy Holidays!

 

 

Hi,

 

Any further questions?

Customer: replied 6 years ago.
replaced relay / turn signals do not work
our power locks had been turning on and off a while back, I do not know if that is related or not. currently the power locks are working and not tuning on and off.

Hi,

 

Do the turn indicators come on in the instrument cluster but do not blink?

 

Do the turn lights come on the outside but just not blink?

Customer: replied 6 years ago.
no turn signal indicators inside or out on either side

Thanks,

 

Check the fuses shown below that are in the same panel as the flasher. If the fuses are ok, then the multi function switch (turn signal switch) will need replaced.

 

 

graphic

Customer: replied 6 years ago.
fuse 6 & 13?

 

Correct.

Customer: replied 6 years ago.
fuse 13 was bad. I have turn signals........YES!!!!!

Sweet!

 

You just saved yourself a lot of $$.

 

Please don't forget to click on accept and leave some feedback.

 

Good Job!

Customer: replied 6 years ago.
do you think the power locks turning on and off had anything to do with the fuse blowing or any idea of what may have caused it to short out?

Hi,

 

The locks are are on a separate circuit so they won't affect the turn signals. As far as why it blew,,,they just do after time. If it does blow again (doubtful) i would think the multi function switch to be at fault.

Customer: replied 6 years ago.
thank you for your help

My Pleasure!

 

Thank YOU for asking!

 

 

Customer: replied 6 years ago.
could you tell me what circuit to check for the power windows. I don't see a fuse so I assume it must be a circuit breaker or relay.

Hi,

 

It's doubtful it would be the circuit breaker, if they go bad, usually they stop working all together. Commonly it is the body control module but would require some very in depth testing to find the fault. If you can follow a wiring diagram, click here to download it.

 

 

 

 


Happy Holidays!

Virtual Wrench and 4 other Jeep Specialists are ready to help you