How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff, ASE Certified Technician
Category: Jeep
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
Type Your Jeep Question Here...
brownjeff is online now
A new question is answered every 9 seconds

Jeep grand cherokee: need diagram to remove starter..4x4

Resolved Question:

need diagram to remove starter on jeep grand cheroke laredo.....2005 4x4 3.7L
Submitted: 6 years ago.
Category: Jeep
Expert:  brownjeff replied 6 years ago.
  • Disconnect and isolate negative battery cable.
  • Raise and support vehicle.
  • NOTE: If equipped with 4WD and certain transmissions, a support bracket is used between front axle and side of transmission. Remove 2 support bracket bolts at transmission. Pry support bracket slightly to gain access to lower starter mounting bolt.
  • Remove two bolts (3) if equipped with an automatic transmission.
  • Move starter motor (4) towards front of vehicle far enough for nose of starter pinion housing to clear housing. Always support starter motor during this process, do not let starter motor hang from wire harness.
  • Tilt nose downwards and lower starter motor far enough to access and remove nut (2) that secures battery positive cable wire harness connector eyelet (1) to solenoid battery terminal stud. Do not let starter motor hang from wire harness.
  • Remove battery positive cable wire harness connector eyelet (5) from solenoid battery terminal stud.
  • Disconnect battery positive cable wire harness connector from solenoid terminal connector receptacle.
  • Remove starter motor.

  • Connect solenoid wire to starter motor (snaps on).
  • Position battery cable (1) to solenoid stud. Install and tighten battery cable eyelet nut (2). Refer to Torque Specifications. Do not allow starter motor to hang from wire harness.
  • Position starter motor (4) to transmission.
  • If equipped with automatic transmission, slide cooler tube bracket into position.
  • Install and tighten both bolts (3). Refer to Torque Specifications.
  • Lower vehicle.
  • Connect negative battery cable.

    Click here to download file

    Customer: replied 6 years ago.
    need diagram
    Expert:  brownjeff replied 6 years ago.

    I sent one just need to download it. Click the download then free trail and download the picture

    brownjeff and 4 other Jeep Specialists are ready to help you

    Related Jeep Questions