How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff
brownjeff, ASE Certified Technician
Category: Jeep
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
11021861
Type Your Jeep Question Here...
brownjeff is online now
A new question is answered every 9 seconds

How to replace 2000 jeep cherokee blower motor

Resolved Question:

How to replace 2000 jeep cherokee blower motor
Submitted: 7 years ago.
Category: Jeep
Expert:  brownjeff replied 7 years ago.

Here is information on the blower motor:

 

REMOVAL

  1. If the vehicle is equipped with air conditioning, recover the refrigerant from the refrigerant system.
  2. Disconnect and isolate the battery negative cable.
  3. If the vehicle is equipped with air conditioning, the accumulator must be relocated in order to service the blower motor. This is done by loosening the accumulator retaining band screw and disconnecting the accumulator inlet tube from the evaporator outlet tube. The accumulator can then be moved far enough to access and remove the blower motor.
  1. Unplug the blower motor wire harness connector.
  2. Remove the three screws that secure the blower motor and wheel assembly to the heater-A/C housing.
  3. Rotate and tilt the blower motor unit as needed for clearance to remove the blower motor and wheel from the heater-A/C housing.

INSTALLATION

  1. Align and install the blower motor and wheel assembly into the heater-A/C housing.
  2. Install and tighten the three screws that secure the blower motor and wheel assembly to the heater- A/C housing. Tighten the mounting screws to 2.2 Nm (20 in. lbs.) .
  3. Plug in the blower motor wire harness connector.
  4. If the vehicle is equipped with air conditioning, connect the accumulator inlet tube to the evaporator outlet tube and tighten the accumulator retaining band screw. See Accumulator for the procedures.
  5. Connect the battery negative cable.
  6. If the vehicle is equipped with air conditioning, evacuate the refrigerant system.
  7. If the vehicle is equipped with air conditioning, charge the refrigerant system.
brownjeff and other Jeep Specialists are ready to help you