How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tim Mohr Your Own Question
Tim Mohr
Tim Mohr, ASE MASTER TECH
Category: Jeep
Satisfied Customers: 15287
Experience:  30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL
17454363
Type Your Jeep Question Here...
Tim Mohr is online now
A new question is answered every 9 seconds

Fuel pump and auto shut down switch located on a 2002 jeep liberty?

Customer Question

where is the fuel pump and auto shut down switch located on a 2002 jeep liberty?
Submitted: 7 years ago.
Category: Jeep
Expert:  Tim Mohr replied 7 years ago.
Hi, my name is XXXXX XXXXX is no inertia switch on this vehicle, you have a different problem, have you pulled codes on this yet?
Customer: replied 7 years ago.

no

Expert:  Tim Mohr replied 7 years ago.
If you sit in the drivers seat and close the door, you must cycle the key on/off 3 times, ending in the on position, the codes will appear in the odometer window, where the mileage is, can you do this?
Customer: replied 7 years ago.
i just did that and it did not give me a code there
Expert:  Tim Mohr replied 7 years ago.
did it say "DONE" ?
Customer: replied 7 years ago.
no, how long do i need to wait before it says that.
Expert:  Tim Mohr replied 7 years ago.
if it doesnt say done, then you did it wrong, start in the of position, then go on/off/on/off/on, and leave it in the on position, it should bring up codes or say done,Tim
Customer: replied 7 years ago.
it not saying anything. i did it 3 times and it never said that.
Expert:  Tim Mohr replied 7 years ago.
then you will need a scanner to pull codes, but as for your problem, if the vehicle was hit hard enough, it is possible the fuel pump popped out of the hanger inside the tank, if you have power at the fuel pump but its not pumping, then you will have to remove the tank and inspect,Tim