How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask moparfl Your Own Question
moparfl, ASE Certified Technician
Category: Jeep
Satisfied Customers: 6330
Experience:  ASE Master Tech Chrysler Dodge Jeep Master Tech
Type Your Jeep Question Here...
moparfl is online now
A new question is answered every 9 seconds

what is the head torque pattern for a 2000 jeep 4.0

This answer was rated:

what is the head torque pattern for a 2000 jeep 4.0
moparfl and other Jeep Specialists are ready to help you
ALLDATA OnlineHome | Account | Contact ALLDATA | Log Out | Help

Select Vehicle | New TSBs | Technician's Reference
Component Search:
Conversion Calculator

2000 Jeep Truck Cherokee 2WD L6-4.0L VIN S

Vehicle Level Engine, Cooling and Exhaust Engine Specifications Torque Specifications Cylinder Head
Cylinder Head

Head Bolt Torque Sequence

Cylinder Head Bolt Identification

Tighten the engine cylinder head bolts in sequence according to the following procedure.

CAUTION: During the final tightening sequence, bolt No. 11 will be tightened to a lower torque than the rest of the bolts. DO NOT overtighten bolt No. 11.

  1. Tighten all bolts in sequence (1 through 14) to 30 Nm (22 ft. lbs.) torque.
  2. Tighten all bolts in sequence (1 through 14) to 61 Nm (45 ft. lbs.) torque.
  3. Check all bolts to verify they are set to 61 Nm (45 ft. lbs.) torque.
  4. Tighten bolts in sequence:
    • Bolts 1 through 10 to 149 Nm (110 ft. lbs.) torque.
    • Bolt 11 to 135 Nm (100 ft. lbs.) torque.
    • Bolts 12 through 14 to 149 Nm (110 ft. lbs.) torque.
    • All bolts are 12 point drives for rocker cover clearance
  1. Check all bolts in sequence to verify the correct torque.
  2. If not already done, clean and mark each bolt with a dab of paint after tightening. Should you encounter bolts which were painted in an earlier service operation, replace them.



© 2009 ALLDATA LLC. All rights reserved.
Terms of Use
Customer: replied 7 years ago.
great job, i feel a lot better about the job. well worth the $9 hopefully I WILLNOT have to use you again but if i have to , you will be the place i get ahold of first
Thanks Glad I could Help.

Related Jeep Questions