How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff
brownjeff, ASE Certified Technician
Category: Jeep
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
11021861
Type Your Jeep Question Here...
brownjeff is online now
A new question is answered every 9 seconds

How to remove the ignition switch from 2003 Wrangler Im

This answer was rated:

How to remove the ignition switch from 2003 Wrangler? I'm referring to this part: http://tinyurl.com/6dbyoo

I will attach the information. The link you put on the question doesn't show what your after? If you still need help just reply, if not click ACCEPT when we are done.

 

Thanks,

 

JB

 

REMOVAL

The ignition key must be in the key cylinder for cylinder removal. The key cylinder must be removed first before removing ignition switch.

  1. Remove key cylinder. (see below)
  2. Remove lower steering column cover screws and remove cover.
  3. Remove the multi-function switch.
  4. Disconnect the electrical connector at the rear of the ignition switch.
  5. Remove the ignition switch mounting screw (IGNITION SWITCH MOUNTING SCREW). Use tamper proof torx bit to remove the screw.
  6. Pull the ignition switch straight out to remove from the locking tabs (IGNITION SWITCH TABS)

1 - Tamper Proof Torx Screw
2 - Ignition Switch

 

1 - Ignition Switch
2 - Locking Tabs

REMOVAL key cylinder

The ignition key must be in the key cylinder for cylinder removal. The key cylinder must be removed first before removing ignition switch.

  1. If equipped with an automatic transmission, place shifter in PARK position.
  2. Rotate key to ON position.
  3. A release tang is located on bottom of key cylinder (KEY CYLINDER RELEASE TANG).
  4. Position a small screwdriver or pin punch into tang access hole on bottom of steering column lower cover (KEY CYLINDER RELEASE HOLE).
  5. Push the pin punch up while pulling key cylinder from steering column.

1 - KEY CYLINDER
2 - RELEASE TANG

 

1 - Lower Cover
2 - Access Hole
3 - Pin Punch

 

 

Customer: replied 8 years ago.

Thank you! I'm reviewing now. The part I want to remove is here (I've already removed the key cylinder)

 

http://www.partsamerica.com/product_images/img/nie/ig8213-1.jpg

 

From you diagram, there appears to be a single Torx screw I need to remove? On my jeep, this is obscured by other parts on the steering column - perhaps the "multi-function switch".

 

Thanks,

-Jeff

I should have sent you what you need. If you still need help just reply, if not click ACCEPT when we are done.

 

Thanks,

 

JB

brownjeff and 3 other Jeep Specialists are ready to help you