How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff
brownjeff, ASE Certified Technician
Category: Jeep
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
11021861
Type Your Jeep Question Here...
brownjeff is online now
A new question is answered every 9 seconds

jeep cherokee: i replace the passenger side (side view mirror)

This answer was rated:

how do i replace the passenger side (side view mirror) on a jeep cherokee 2000 (Limited)
power mirror or manual?
Customer: replied 8 years ago.
power mirror

POWER MIRROR

  1. Disconnect and isolate the battery negative cable.

Remove the screws that secure the front door trim panel to the inner door panel

  1. Using a trim stick or another suitable wide flat-bladed tool, gently pry the front door trim panel away from the door around the perimeter to release the trim panel retainers

    NOTE: To aid in the removal of the trim panel, start at the bottom of the panel.

  2. Lift the front door trim panel upwards and away from the inner door panel far enough to disengage the top of the panel from the inner belt weatherstrip.
  3. Pull the front door trim panel away from the inner door far enough to access the inside door latch release and lock linkage rods near the back of the inside door remote controls.
  4. Unsnap the plastic retainer clips from the inside door remote control ends of the latch release and lock linkage rods, and remove the rod ends from the inside door remote controls.
  5. Unplug the wire harness connectors from the door power switch module or, on the driver side only, the stand-alone power mirror switch.
  6. Set the front door trim panel aside.
  7. Remove the one screw that secures the front door flag trim to the inner door panel
  8. Using a trim stick or another suitable wide flat-bladed tool, gently pry the door flag trim away from the inner door to release the trim panel retainer.
  9. Unplug the power mirror wire harness connector.
  10. Remove the three screws that secure the power mirror to the inner door panel
  11. Unseat the power mirror wire harness grommet by pushing it out through the hole in the door flag from the inside.
  12. Pull the mirror and seal from the outside of the door while feeding the wire harness, grommet, and connector out through the hole from the inside of the door.
  13. Reverse the removal procedures to install. Tighten the mirror mounting screws to 4.3 N·m (38 in. lbs.) Tighten the door trim mounting screws to 2.2 N·m (20 in. lbs.)

If you still need help just reply, if not click ACCEPT when we are done.

Thanks,

JB

brownjeff and 2 other Jeep Specialists are ready to help you