How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Richard Your Own Question
Richard
Richard, Jaguar Technician
Category: Jaguar
Satisfied Customers: 15340
Experience:  12 years at a Ford/Lincoln Mercury and Jaguar dealer as technician and shop foreman.
10437779
Type Your Jaguar Question Here...
Richard is online now
A new question is answered every 9 seconds

02 jaguar xtype codes p1367 and p1368 car not running

Customer Question

02 jaguar xtype codes p1367 and p1368 car not running
Submitted: 1 year ago.
Category: Jaguar
Expert:  Richard replied 1 year ago.

I assume that the engine is cranking normally but not starting? Any recent work done to the vehicle?

Customer: replied 1 year ago.
IT WILL RUN WHEN COLD FOR A FEW SEC THEN STOP RUNNING UNTIL IT GET COOL AGAIN
Customer: replied 1 year ago.
WORK WAS DONE ...COMPUTER HAD OIL IN IT SO IT WAS CLEANED AND IGN RELAY WAS REPLACED
Expert:  Richard replied 1 year ago.

Ok the ECM can be the problem. I would first recommend we check the ground on the alternator bracket to make sure it is clean and secure. We also should make sure we have battery voltage to the coils with the ignition on. Let me know. The problem is if a new or used ECM is installed the security system must be programmed.

Customer: replied 1 year ago.
GROUND AND VOLTAGE IS GOOD
Expert:  Richard replied 1 year ago.

Ok look closely at the wire harness to make sure there are no signs of damage . For some reason the ECM is cutting off the ignition. Did you have the problem before the ECM was repaired.

Related Jaguar Questions