How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Gary Your Own Question
Gary
Gary, Technician
Category: Jaguar
Satisfied Customers: 15914
Experience:  GM master tech for 15 years/ASE master tech for 20 years
19513769
Type Your Jaguar Question Here...
Gary is online now
A new question is answered every 9 seconds

How to remove power steering pump 2000 jag xj8 top or under

Customer Question

how to remove power steering pump 2000 jag xj8 top or under car I also will replace water pump
Submitted: 1 year ago.
Category: Jaguar
Expert:  Gary replied 1 year ago.

I am sorry for the long wait

the water pump is changed up through the top of the engine compartment and here is the water pump procedure

  1. Open the engine compartment and fit paintwork protection sheets.
  2. Drain the radiator Retain the coolant drain tray in position to catch any spillage when removing the water pump.
  3. Remove the supercharger drive belt
  4. Slacken the three screws, which secure the water pump pulley.
  5. CAUTION: When releasing the belt tension, never apply any torque in a clockwise direction to the pulley center bolt (left hand thread) as it could subsequently loosen.
  6. Remove the drive beltfrom the generator and accessory drive.
    Use a spanner e.g. Churchill JD-230 or Snap On XDHM 1415, on the center bolt of the belt tensioner idler pulley, to turn the adjuster assembly to the left against spring tension.
    Whilst holding the tensioner against spring tension, remove the drive belt from the generator pulley. Release the tensioner slowly and remove the spanner.
    Disconnect the belt from the other pulleys, as necessary, to move it clear of the pump pulley.

  7. Remove the pulley from the water pump. Remove the pulley securing screws.
  8. Remove the pulley from the water pump.

  9. Remove the water pump. Remove the five bolts, which secure the water pump.
  10. Remove the water pump from the engine.

  11. Remove the gasket. Remove and discard the water pump gasket.
  12. Remove and discard the water pump O-ring seal.

  13. Clean any coolant spillage from the engine compartment.
  14. Clean all relevant parts and sealing faces.
  15. Installation

  16. Installation is the reverse of the removal procedure. Tighten the pump securing bolts to 11-13 Nm and the pulley bolts to 10-14 Nm
Expert:  Gary replied 1 year ago.

here are the pictures of the water pump procedure

Expert:  Gary replied 1 year ago.

one more

Expert:  Gary replied 1 year ago.

as for the power steering pump once the drive belt is off it is a matter of removing the 2 lines into the pump and removing it up through the top just like the water pump